Hellwig Sway Bar 7722 User Manual download pdf

7722 (R-7722) 07/02/2012

SAFETY

: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE AND CHOCK THE

WHEELS.

NOTE:

TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST

BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE THE VEHICLE BY THE FRAME.

NOTE:

THIS UNIT IS DESIGNED TO MOUNT IN THE FACTORY LOCATION

TORQUE TABLE

Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs

1. Remove factory sway bar and end links. Keep the factory

hardware since some of it will be reused.

2. Lubricate the insides of the D-shaped polyurethane bushings

and place them on the Hellwig sway bar. Then place the U-

plates over the bushings.

3. Bolt the U-plates to the underside of the frame in the stock

location using the factory bolts as shown in Photo 2. Leave

loose at this time.

INSTALLATION INSTRUCTIONS

Front Sway Bar

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

559-734-7451 800-367-5480 FAX 559-734-7460

1 2

7722 (R-7722)

Page 2

4. Swing the sway bar arms up until they are parallel to the ground and then assemble the end links fol-lowing the diagram above and Photo 3. 5. Mak

No comments

Hellwig Sway Bar 7722 User Manual