INSTALLATION INSTRUCTIONS 1997-2006 Jeep Wrangler TJ (Coil Sprung Front Suspension) 7870 FRONT STABILIZER BAR Thank you for purchasing a quality Hellw
1. Remove the front factory sway bar by unbolting the plastic cover piece on the bumper, unbolting the u-plates behind the bumper on the top of the f
6. Loosely attach the rod end to the middle hole on the sway using the 7/16” bolt, washers and stover nut. The middle hole position is for sizing the
11. On the inside of each D Bushing, place the collar to prevent lateral movement and tighten the allen head screws to 7-8 ft-lbs. See Photo 3. 12. Re
Comments to this Manuals