Hellwig Sway Bar 7269 User Manual download pdf

TORQUE TABLE

Bolt Size 3/8”— 25 ft lbs * Bolt Size 7/16”— 35 ft lbs* Bolt Size 1/2”—60 ft lbs *

SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE

AND CHOCK THE WHEELS.

NOTE: TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE

VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE

THE VEHICLE BY THE FRAME.

NOTE: THIS UNIT IS DESIGNED TO MOUNT TO THE BOTTOM OF THE AXLE TUBES WITH

THE ARMS OF THE BAR TOWARD THE REAR OF THE VEHICLE.

1. Place the D shaped bushings onto the straight areas of the bar on each side of the center hump.

2. Hold bar up to the axle and locate the position on the axle tubes to mount the u-bolts. Be sure to put the

U-Bolts Under AnyBrake Lines, Wires or Hoses on the Axle to Avoid Any Possible Damage. The

threads of the U-Bolts will point down.

3. Remove brake cable/line bracket from axle and use single flat plate to relocate higher.

4. Place saddle brackets onto the U-Bolts on the axle tubes. The saddle brackets have different radius to ac-

commodate the taper in the axle tube. If they do not sit square, reverse their orientation. Place the U-Plates

over the D shaped bushings on the bar and attach the bar to the U-Bolts and saddle brackets with the flat wash-

ers and nuts provided. LEAVE LOOSE AT THIS TIME to allow for adjustment later. For additional bar

clearance remove the driver side lower shock bolt, turn it around and reinstall from the opposite side of

the lower shock bracket.

INSTALLATION INSTRUCTIONS

Rear Stabilizer Bar 7269

2001-2006 GM 2500HD-3500HD 2WD-4WD

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

Remove shock bolt and rein-

stall with bolt head facing out-

board for sway bar clearance.

7269 (R-7269) 11/19/2010

1 2

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

TORQUE TABLEBolt Size 3/8”— 25 ft lbs * Bolt Size 7/16”— 35 ft lbs* Bolt Size 1/2”—60 ft lbs *SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE

Page 2 - Passenger Side

5. Locate existing spare tire crossmember on vehicle frame. Place square U-bolt over the frame rail in front of the crossmem-ber with legs of the U-bo

Comments to this Manuals

No comments

Hellwig Sway Bar 7269 User Manual

Browse online or download User Manual for For the car Hellwig Sway Bar 7269. Hellwig Sway Bar 7269 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Hellwig Sway Bar 7269